The article presents the results of analysis of operational parameters of piston engine CA 912 ULT which is a propulsion system of ultralight gyroplane Tercel produced by Aviation Artur Trendak. Research was conducted under normal operating conditions of the autogyro and data was collected from 15 independent tests including a total of 14 flight hours conducted during training flights. Engine and flight parameters were recorded at 9 Hz during each flight using on-board Fligh Data Recorded system. Collective results were presented to show the statistical analyses of the individual parameters by determining the mean values, standard deviations and histograms of the distribution of these parameters. The analyses included engine speed, charge pressure, air temperature, oil temperature and exhaust temperature. Histograms of operating points defined by both engine speed and manifold air pressure were also determined. Analyses were carried out to determine the contribution of steady-state and transient engine operation. It was also shown that the dynamics of engine work in real operating conditions is small. Detailed analyses were conducted for steady-state conditions. The value of the engine load index was determined and its statistical analyses were carried out. It was shown that the engine operating points are concentrated mainly in the range of idle and power above 50% of nominal power. The most frequent range is 50% to 80% of nominal power.
Andrych-Zalewska M, Chłopek Z, Merkisz J, Pielecha J. Evaluation of the test drive cycle conditions impact on exhaust emissions from an internal combustion engine. Combustion Engines. 2018;175(4):3-9.
Czarnigowski J, Wendeker M, Jaklinski P, Nazarewicz A, Piertykowski K, Geca M, et al. Model of injection system for SI radial aircraft engine. SAE Technical Papers 2007-01-1903. 2007.
Markowski J. Correction of the model for assessing the emission of harmful exhaust emissions from the engine of a small aircraft during the flight. Transp Res Proc. 2018;(35):230-239.
Bakholdin D, Biryukov V, Tolstobrova L. Determining parameters of electric power unit for light aircraft. AER Adv Eng Res. Proceedings of the International Conference Actual Issues of Mechanical Engineering (AIME 2018). 2018;(157):65-69.
Jakliński P, Wendeker M, Czarnigowski J, Duk M, Zyska T, Klimkiewicz J. The comparison of the operating parameters in an aircraft radial piston engine fuelled by 100LL and ES95 gasoline. Combustion Engines. 2009;136(1):52-59.
Czarnigowski J, Jakliński P, Zyska T, Klimkiewicz J. Analysis of influence of legal requirements on the design of electronic ignition system for aviation piston engine. Journal of Kones. 2017;24(1):91-100.
Kwon H, Park Y, Shin C, Kim J-H, Kim C-G. In-flight strain monitoring of aircraft tail boom structure using a fiber bragg grating sensor based health and usage monitoring system. Int J Aeronaut Space. 2021;22(3):567-577.
Zhu L, Li N, Childs PRN. Light-weighting in aerospace component and system design (2018) Propul Power Research. 2018;7(2):103-119.
Rohani SV, Jahangirian A. A fast and efficient method for multiobjective aerodynamic optimization of a civil aircraft fuselage. J Aerospace Eng. 2022;35(6).
Sabater C, Stürmer P, Bekemeyer P. Fast predictions of aircraft aerodynamics using deep-learning techniques. AIAA J. 2022;60(9):5249-5261.
Song C, Liu H, Zhou Z, Luo X, Li W. Inverse design of aerodynamic configuration using generative topographic mapping. Xibei Gongye Daxue Xuebao/Journal of Northwestern Polytechnical University. 2022;40(4):837-844.
Shen Y-G, Nie K, Xu J-S, Chen G-S. Combustion and emission characteristics of compression- ignition aero piston engine at different altitudes. Tuijin Jishu/Journal of Propulsion Technology. 2022;43(4).
Zhao Z, Cui H. Numerical investigation on combustion processes of an aircraft piston engine fueled with aviation kerosene and gasoline. Energy. 2022;(239):122264.
Grabowski Ł, Karpiński P, Rudzik D. Study on operating load of the compression ignition engine. Combustion Engines. 2017;168(1):168-171.
Heywood J.B. Internal Combustion Engine Fundamentals. McGraw Hill, New York, 1988.
Bai M, Yang W, Song D, Kosuda M, Szabo S, Lipovsky P, Kasaei A. Research on energy management of hybrid unmanned aerial vehicles to improve energy-saving and emission reduction performance. Int J Env Res Pub He. 2020;(17):2917.
Yuhimenko V, Baimel D. Sitbon M, Averbukh M, Lineykin S, Kuperman A. Hybrid internal combustion engine based auxiliary power unit. Micromachines. 2020;(11):438.
Zhao X, Guerrero JM, Wu X. Review of aircraft electric power systems and architectures. Energycon 2014 – IEEE Int. Energy Conf. 2014:949-953.
Song J, Cha J. Analysis of driving dynamics considering driving resistances in on-road driving. Energies. 2021;(14):3408.
Bieniek A, Brol S, Mamala J. The system for estimation parameters of internal combustion engine in the road test. Journal of Kones. 2011;18(2):279-286.
Sureshkumar J, Venkitachalam G, Mallikarjuna JM, Elayaraja R. Study on effect of engine operating parameters on flame characteristics. SAE Technical Papers 2015-01-0749. 2015.
Gao Y, Checkel MD. Emission factors analysis for multiple vehicles using an on-board, in-use emissions measurement system. SAE Technical Papers 2007-01-1327, 2007(724), 776–790.
Bera P. Torque characteristic of SI engine in dynamic operating states. Combustion Engines. 2017;171(4):175-180.
Wendeker M, Jakliński P, Czarnigowski J. Experimental analysis of automotive engine conditions of operation. Eksploat Niezawodn. 2000;(6):19-28.
Aviation Artur Trendak TERCEL Carbon RSTi Aircraft Maintenance Manual TERCEL-C-AMM-001-EN Edition 1 28 Oct 2020.
Boriboonsomsin K, Durbin T, Scora G, Johnson K, Sandez D, Vu A, et al. Real-world exhaust temperature and engine load distributions of on-road heavy-duty diesel vehicles in various vocations. Data Brief. 2018;(18):1520-1543.
Journals System - logo
Scroll to top